View Single Post
      04-29-2012, 06:57 PM   #94
tracer bullet
Captain
 
tracer bullet's Avatar
 
Drives: '11 135i - AW w/ TC
Join Date: May 2011
Location: Saint Paul, MN

Posts: 717
iTrader: (1)

Quote:
Originally Posted by imported_pinoy View Post
Its a dead LED bulb code, there is no moisture in my headlight housing, everything is dry. The housing is almost fool proof, metal clamps will not snap closed if housing cover isn't properly placed.

Thanks for your concern. I e-mailed Mike@N54tuning regarding the issue to see what I can do from here.
No moisture is good. However I disagree on it closing - when I first put mine on my clamps closed and everything certainly appeared tight (I'm anal retentive and I checked thoroughly, I thought). Well once I got liquid water in there from the dealer's car wash after an oil change, I knew that wasn't the case!

I don't know if I pinched a wire in the seal or the location of the ballast was in a place that pushed back on the cover, but either way it was in the right position and the clamps closed, and still there was a path for water to get in.
tracer bullet is offline   United_States
0
Reply With Quote