View Single Post
      05-01-2012, 04:57 PM   #1
Eddy@ApexRaceParts
BimmerPost Supporting Dealership
84
Rep
1,607
Posts


 
Drives: E30 M3, 2011 335d
Join Date: Jun 2009
Location: Bay Area, CA

iTrader: (5)

Post Volunteer Test Vehicles Needed for EC-7 Wheels

The EC-7 wheel prototypes are here in 13 sizes, 7 of which are new to APEX, so we are looking for a wide range of vehicles to test these wheels on. If you are willing to travel to Livermore (San Francisco Eash Bay) for some test fitting and photos, then please contact us. This is a great opportunity to see this new wheel design on your own car, and to confirm fitment.



Some wheels are made in specialty sizes/offsets that require specific modifications for proper installation, Below is a list of vehicles we are interested in, along with the required or preferred modifications for each vehicle type.

1 Series: camber plates required, BBK preferred

1 series: lowering springs only


E36 M3: camber plates required, BBK preferred

E36 M3: Camber plates required, front/rear fenders rolled/flarred to fit 18x10's with 285's

E46 non-m: camber plates required, BBK preferred

E46 M3: camber plates required, Brembo 380mm required

E46 M3: camber plates required, 355mm BBK required

E9X non-m: camber plates required, BBK required

E9X non-m: only lowered suspension.

E9X M3: Brembo 380 BBK required

Z3 M: camber plates required

Z4 non-m: camber plates required

Z4 M: camber plates required, BBK Required

Z4 M: lowering springs only

If you would like to volunteer please contact us at: info (at) apexraceparts (dot) com and title your email "EC-7 test vehicle".

http://www.myapexparts.com/2012/05/0...r-ec-7-wheels/
__________________

Last edited by Eddy@ApexRaceParts; 05-01-2012 at 05:05 PM.