Originally Posted by GaryS
Induktion is primarily an Audi shop, but there is always at least one E36 or E46 M3 there for service whenever I've been there. I went there the first time because TrackDaze recommended them for a track inspection.
Since then, they've installed some rear control arms for me, changed my Dinan air filter (in the bumper), flushed the brakes and coolant, installed my BBK, and sent my car out for an alignment.
The OP asked about getting a bumper and exhaust installed. I would definitely go to Induktion for that stuff.
what about fab work? That's the kind of work I'm looking to get done...I looked at some of their In Shop pictures on their website and looks like the dudes can weld pretty well..
Originally Posted by Nate4641
looks like unicorn vomit.
| 2005 s2000: KPRO, Invidia q300 v4, PLM header, BERK 70mm HFC, Vortech v2 (3.6" Reichard Pulley), FMIC, ID 725cc (397whp/243tq @9psi), Tuned at Innovative Motorworks.
| 2008 135i: PTF Tune, RB Turbos, ER CP, TiAL Q, BMS OCC, BMS DCI, AA 2.0 FMIC, VRSF 3" DPs, Berk Mids, CP-E Axleback, Robs' PCV.