View Single Post
      10-27-2012, 11:34 AM   #32
Dackelone
Moderator
 
Dackelone's Avatar
 
Drives: 135i Silber mit/Rot 6MT N54
Join Date: Feb 2010
Location: Bayern, Germany

Posts: 15,665
iTrader: (1)

Quote:
Originally Posted by OrangeCrush View Post
Hey Dack! I just installed my blacklines but I am worried I did incorrectly. Did you remove one of the plastic washers off of your new lights before installing? I noticed on the original lights that one of the 3 bolts didn't have the washer on it. And now looking at it, I noticed that this washer sits a little on the seal. It is the one closest to the license plate. Do think this will cause an issue with the seal?
I do not think mine had any washers.

Q). is how do your tail lights fit? IF they are flush I would not worry about it. You could also try and water test them, and pull some of the inner truck carpet out and check for any leaks. But I am fairly sure mine Blacklines only had that foam gasket and no washers on the studs or threads.


Dack
Dackelone is offline   Germany
0
Reply With Quote