View Single Post
      10-31-2012, 09:16 AM   #10
Brigadier General
Harlequin's Avatar

Drives: F32 Coupé
Join Date: Mar 2011
Location: Brisbane, Australia BMW Club QLD Member

iTrader: (5)

Garage List
Originally Posted by skeeler View Post
1) I am assuming you have to remove all of the factory bolts in the front part of the spoiler?
Yes. But there's only 6 or so of them.

Originally Posted by skeeler View Post
2) Does the splitter use some of these existing factory holes to mount to then?
Yeah but you want to use more than just those. You'll notice that the splitter has some "circles" etched into it. Drill a hole for each of those. Some of them will line up with the pre-existing holes on the bumper, some you will need to create new ones.

Originally Posted by skeeler View Post
3) I noticed you mentioned that you need to remove the front splash shield from the center splash shield and finally from the vehicle, but when reinstalling the front splash shield, how does it attach if you have used the factory mounting holes for the splitter?
Mine's basically just resting on top of the trailing edge of the bottom of the bumper - tucked in, so to speak.

Hope that helps.