Thread: Milltek on 1m
View Single Post
      11-20-2012, 05:24 AM   #6
shichen
M
 
Drives: 1m VO/Milltek exhaust/GTS Rim
Join Date: Sep 2012
Location: Taipei

Posts: 46
iTrader: (0)

Quote:
Originally Posted by Chris ABP
I fitted a full Milltek system to my 1M and think I may know what the problem may be....

Do your right hand side tailpipes sit higher than the left side? And my guess is that the pipework is very close to the small metal bracket on the left of the rear diff housing?

If so the system sinply hasn't been fitted properly. All of the sleeves need to be fully pushed home and the mounting in the near to the centre section is adjustable. Once the system is installed and aligned properly there is no noise, clearence to the diff is perfect and it sits level on the rear. I know this as I had the same problem on my car after a rushed installation so I took my time the second time and its now perfect.

Chris
👍Yes Chris
Exactly... My right tip is a tiny bit higher than the left
It really bothers me
N sometime somewhere of the exhaust clashing with some part of the metal when the road is bad
So... I will ask my milltek shop to reinstall n recheck for me n forward your feedback to them
Hopefully it will fit perfectly again
I love the sounds really mellow and warm
Just this problems bother me all the time
Thx u so much
Will keep u guys updated after its done
^^
shichen is offline   Taiwan
0
Reply With Quote