View Single Post
      12-12-2012, 07:07 AM   #32
flinchy
Colonel
 
Drives: 130i
Join Date: Nov 2011
Location: QLD, Australia

Posts: 2,742
iTrader: (0)

Quote:
Originally Posted by ChristianReyess View Post
our cars shouldn't be driven to redline, we lose retarded amounts of power towards the end of our RPM range. Or atleast that is how I feel with my baby.


And a JB4 would get you your PSI levers and it is very sensitive and accurate. As mentioned before.
erh, just check out the graph just posted, you'll see it's only a moderate drop from 5,500rpm peak... 310-290 at 6500rpm, you could work it out based on gear ratios the optimum shift point, it'll be somewhere between 6500-7000... i'll work it out tomorrow sometime, i'm too tired for math

JB4 doesn't get you a SUPER accurate gauge, only your temp gauge hijacked.

Quote:
Originally Posted by Adam135 View Post
Yeah, I don't normally go past about 5500rpm.

lol why? just losing acceleration

the second benefit of shifting higher, is if you shift at say 6250rpm, the higher gear will be waaay off he low side of the power band, probably even down below 250hp in that graph

shift at 6500-7000, even as low as 280hp, and you'll 'drop down' into a much higher 270-280 range.. and 280hp in 2nd gear has more acceleration than 280hp in third, so either way, staying in the higher gear until AT LEAST 6500rpm gives you better acceleration...

acceleration isn't about peak power, it's about average power, how much area there is below you on the graph... i could work it out better if the dyno operator actually stuck it to above 6500, it may very well be worth going much closer to 7000.
flinchy is offline  
0
Reply With Quote