Thread: P3 Vent
View Single Post
      12-23-2012, 07:28 PM   #5
BMW86
Major General
 
Drives: 135i CLA45 AMG Ninja
Join Date: Jul 2008
Location: Australia

Posts: 8,934
iTrader: (0)

Quote:
Originally Posted by Ian///M View Post
Punch through the rubber firewall under the steering, thread it through th brake servo area, then over the engine wiring harness, securing with cable ties.
Quote:
Originally Posted by Newby View Post
I went across the firewall inside car, where the loom runs, and punched a hole in the yellow "plug/ cover" (would be where steering column is if it were lhd) and ran it up the inner wheel tub and T'd it into the bov vacuum lines.
There's no one way to do it but I find this way the cleanest installation.
__________________
BMW 135i N54 TWIN TURBO
Quarter Mile 12.173@113.70mph - Street Tyres
Queensland Raceway Sprint 1:01:22 - Street Tyres
Queensland Raceway Clubman 1:04:74 - Street Tyres
Lakeside Raceway 1:03:97 - Street Tyres
BMW86 is offline   Australia
0
Reply With Quote