Thread: Brake slack
View Single Post
      01-01-2013, 06:19 PM   #12
sparoz
Brigadier General
 
sparoz's Avatar
 
Drives: VO 1///M; AW X3 30d
Join Date: Jun 2008
Location: Sunshine Coast

Posts: 4,744
iTrader: (0)

Quote:
Originally Posted by E30 Racer View Post
Certainly sounds like it. Have you discussed the issue with Brembo directly?
Not yet, as I think the problem is with the installation. The brake works beautifully once the pressure is up.

Quote:
Originally Posted by Pig Farmer View Post
I had the same issue when installing my Stoptech BBK. After the pads are somewhat bedded, go out and get the anti-lock to engage a few times. Then bleed the brakes using the two person method with the engine running. This worked for me. This was not required for subsequent fluid changes. A pressure bleeder works fine once all the air is removed from the system but it doesn't seem to build up enough pressure to push all the air out of the system. Also, I believe there is a way to activate the anti-lock system through the ECU, but I'm not sure how to do it?
Yeah, I will check if they have done the GT1 bleed.
__________________
1///M - Valencia Orange
X3 30d - Alpine White

Under Six Seconds http://www.under6s.com
sparoz is offline   Australia
0
Reply With Quote