Does any body know When will LCI Black lines be available for 2012 halogens models? (without messing with wires) I neeeeed them so bad.
Quote:
Originally Posted by viciousgook
Not that I am aware of, wires are just wires to me lol, not much of an electrician and sure as hell I suck at wiring.
It's been a long time since I had my tail lights re-wired.. Around two years ago? So I'm not entirely clear on what I did EXACTLY back then. When I did the xenon headlight conversion I had my tail lights wired up correctly and coded to work with the xenon retrofit.
In all honesty, if it works fine now I would just leave it, unless you're really OCD about them. We seriously need a sticky for the LCI Halogen guys so they will stop asking the same question
|
Quote:
Originally Posted by Gray_Panther
I just installed them. Here is what I did to swap wires:
-take a pick (similar to what dentists use) and on the sides of the connector you will see that it unlatches.
-take the pick on each end and pry off.
-take the pick and stick it where you see the metal clip right below the latch (where the pins connect to).
-push in the metal clip and push up and out. That clip holds the pin socket in place. You can grab the wire and wiggle it out at this point.
-Then just slide it into the other socket until you hear a click. Voila.
|