Trying to install the races on my blackline LSD and hitting a snag.
I see that the bearing race sitting on the factory carrier goes down past the carrier. It's not flush, the carrier protrudes out of the race maybe a couple of MM.
Example:
But now trying to press the race onto the blackline, I have only gotten it this far (Flush with the end of the carrier):
View post on imgur.com
I don't really know what I can use to smack it on there... it's like maybe 48mm ID? I tried using a piece of PVC coupler but I don't think it's strong enough.
I noticed in the OP's picture the race isn't fully installed.
What did you guys use to get it all the way down?