Quote:
Originally Posted by bradford
I'm ready to buy now. Here's my shopping list:
Moton street sport dampers
Rear strut adapted to fit the E92 lower camber arm (IE horizontal pin solid mount, as opposed to the vertical rubber bushing on the 135i/335i)
450/800 spring rates, preferably Swift springs
Potentially Moton camber plates if they will not be noisy.
|
Then send me an email and I will get working on it.
Notes:
- We will NOT be making a horizontal mount for the strut - we would likely make a mount to allow use of the vertical pin shaft the way Moton is producing them
- We can provide the dampers with the 2.25"/60mm perches, but if purchased from us, we use Hyperco springs - sourcing other brands will place fitment responsibility on the customer
- Moton camber plates again use the 2.25"/60mm mount included with the dampers and do not add noise in my experience due to the bearing quality used
- On our One Lap 135, I used 800/1200# springs. As the rate comes down, I tendd to go with a little less rear percentage. Calculations will tell you something, but experience will likely be the better guide
James