View Single Post
      12-02-2010, 07:54 PM   #1
1zie
Enlisted Member
 
Drives: 2008 128i
Join Date: Nov 2010
Location: Newfoundland

Posts: 40
iTrader: (0)

DIY Alcantara steering wheel trim

Not sure if this has been posted before, but here it is. It's a seriously easy install.
Pics were taken with my phone so please don't expect SLR quality.

Needed: T20 torx bit, small flat head, small phillips head. 10 min

Step 1: Remove the screws holding the stock trim in place. The three screws can be found on the back side of the three steering pillars. (T20 torx bit)

Step 2: Using your replacement trim, locate the clips found at the top (indicated by the X) Use a right angle tool, or a small flat head screw driver to release the clips


Step 3: Gently remove the trim by pulling down and away slightly from the wheel. DO NOT YANK as the control wires are directly attached to the trim.


Step 4: From the reverse side of the trim, unscrew the remotes from the trim housing (2). The connection wires will be thread downwards from right to left.


Step 5: Reverse previous steps. Attach remotes to new trim, make sure to feed connection wires in the designated housing on reverse side. Once new trim is back in place, screw torx bits a small amount 1 at a time. Do not over torque. enjoy your new found Alcantara.
1zie is offline   Canada
0
Reply With Quote