View Single Post
      04-15-2011, 08:11 PM   #17
larryn
Major General
 
Drives: '97 332ti, '10 E92 M3
Join Date: May 2005
Location: Seattle

Posts: 8,436
iTrader: (2)

Quote:
Originally Posted by fboutlaw View Post
Just installed the Vorshlaq camber plates this last weekend with the Dinan suspension (stock size springs, koni struts) and while the process is a pain to install them, it was pretty straight forward. So far I've had no noise from the plates, but I can see how some would. You need to re-use the stock rubber protector ring at the top of the springs, that way there's no metal on metal contact. If you leave out the rubber ring you'll have metal on metal rubbing and probably noise.
I do have the rubber installed. that is not where it is making contact. It is the upper spring perch making contact with the plate itself. It actually rubs a groove into the aluminum upper spring perch. the issue is that the bearing stack is not tall enough for my setup. I'm very dropped and have more than -3deg.... I've seen the exact same thing on another Vorschlag 135i install too... that caused the driver to move to Dinan non-adjustable plates.
larryn is offline   United_States
0
Reply With Quote