Thread: Alarm DIY
View Single Post
      04-17-2008, 09:22 PM   #5
ChrisK
Major General
ChrisK's Avatar
United_States
4449
Rep
7,594
Posts

Drives: '19 M2C
Join Date: Jun 2007
Location: Chicagoland

iTrader: (7)

Garage List
Step 3:

Next, we need to install the ultrasonic glass break sensor. It is installed inside the rear cabin light assembly located on the roof of the car. Use a Popsicle stick at the end facing the front of the car to release the clips, and it should come our easily. Remove both cables. Take the glass break sensor and snap it into place. Reconnect both cables (black for the sensor and white for the light assembly) Re-install the light assembly the same way you took it out. Start with the end closest to the back of the car and then press the opposite end up.
Attached Images
    
__________________
www.ReTuneTheDeTune.com
2019 M2 Competition (Sunset Orange)
Appreciate 0