Quote:
Originally Posted by GAZ 345
when i had my mid pipe off one of the studs was quite tight,any body know what thread these are,made me think what if this snapped how would i get it out,looking at the picture it looks like it would knock out
|
Yea... mine were kind of rusty and tight too. I just soaked the threads with some WD40 for a while before trying to loosen them. WD40 or Liquid Wrench is your friend.
RealOEM.com says the nut is a M8. So the stud threads are probably M8 x 1.50 thread pitch. It could be M8 by 1.25 as well, but I think its 1.50. I believe I used a 13mm socket for the M8 nut.
I coated the threads with some high temp copper anti seize... just to make life easier next time I go in there.