Quote:
Originally Posted by Angerman
So a 15-45 minute install took about 3 hours. Whoever does the install in 15 minutes I would like to meet because that shit in itself is frustrating. Took me forever to figure out what map I was on and figure out the steering wheel controls, but I finally got my car to crank. Wouldn't turn on for a while and figured out had the wiring backwards with the pins, go figure. Anyway, when I'm WOT past 3500RPMS (doesn't do it before that) my hazard lights come on in the cluster (solid, not blinking) but they aren't on the outside of the car, only the cluster shows it. Anyone have this situation before?
|
You probably adjusted the shift light setting to 3500. It's displayed threw the hazard lights.
http://www.n54tech.com/forums/showthread.php?t=10605
Check this out you can adjust that setting higher. This link is very helpful on how to set up your jb4. Make sure you watch the videos. Good luck.