|
Thanks so much! I'm so glad I found this post. I was able to fix my '13 in about 20 minutes. Here are a few more tips:
* I used bolt cutters to remove the stopper brackets. They snipped off quickly and cleanly at the welds with no sparks and without deforming the rest of the guide bracket.
* The nuts to the seat back take a 13mm socket.
* Keep the rear seat belts out of the way by looping the webbing around the front seat belt guide anchors.
* When pushing the seat belt buckles back through the seat bottom, make sure the release side is facing inboard and the tongue insert side is facing outboard.
|