This is a quote from the JB3 PnP Instructions located
HERE
Quote:
Gas pedal map switching:
Starting with JB3 software version 1.2 (e.g. your JB3 control module has a 1.2 or larger
number written on the bottom of it), maps can be selected via a hidden gas pedal menu
OR via a hardwire switch. In addition to the stock map, there are six performance maps,
and numerous diagnostic and special needs maps. Do not select a map higher than 7
unless directed by BMS.
To engage JB3 gas pedal map switch mode press and hold gas pedal with engine off /
ignition on for 4 seconds, and then release gas pedal. This will put the JB3 in map listen
mode and also enable map 0.
Once in listen mode to cycle through maps press and release the gas pedal the number of
times needed for your desired map. For example for map 3, "high boost" press and release
gas 3 times. You do not need to hold the pedal down, a quick press to floor and release
will do. Start the motor and your map will be saved until changed.
If also equipped with the 3 position wire in switch, the middle position enables gas pedal
map switching, the red dot forces map 7, and the black side forces map 3. If equipped with
the RixEffects vent mount boost gauge, consult with RixEffects for mapping details.
|
Hope this helps :thumbup:
__________________
M235i Auto: Alpine White / Black Dakota Leather, Brushed Aluminium / High-gloss Black Interior, Driver Comfort / Professional Media / Sun Protection Packages, Harman Kardon Hi-Fi, Enhanced Bluetooth, Lumbar & Heated Seats, Adaptive M Sport Suspension