View Single Post
      07-23-2013, 06:12 AM   #48
Autobotvu
Private
11
Rep
98
Posts

Drives: 128i fully equpped
Join Date: May 2013
Location: San diego

iTrader: (1)

update car comes 24 to port hueneme then installs performance exhaust and kidney grills will arrive me in san diego 29th.

I have bought a couple more things for detailing lol spent prob close to 1400

Found out I bought wrong p21s wheel spray had to buy Gel heard it was better.

Leatherique 16oz. Kit
P21S Gel Wheel Cleaner 500 Ml Kit
Optimum Opti-Seal - 8 oz
Brinkmann 800-2200-0 Dual Xenon Rechargeable Spotlight
P21S 100% Carnauba Paste Wax
PORTER-CABLE 7424XP 6-Inch Variable-Speed Polisher
1 Chemical Guys Black on Black - 11 oz
1 Chemical Guys Grime Reaper A.P.C. - 16 oz (w/CG Clear Trigger)
1 Einszett Cockpit Premium - 500 ml
1 DI Brushes Boar's Hair Detailing Brush - 1"
1 Meguiar's Ultra-Cut Compound M105 - 32 oz
1 Meguiar's Ultra Finishing Polish M205 - 32 oz
1 Lake Country Pink Very Light Cutting Pad - 5.5 inch
1 Lake Country Hydro Tech Cyan Light Cutting and Polishing Pad - 5.5 inch
1 Lake Country 3" Backing Plate for Porter Cable 7424 XP - 73 mm
1 Lake Country 5" Backing Plate for Porter Cable 7424 XP - 125 mm
1 Lake Country Pink Very Light Cutting Pad - 4 inch $
1 Lake Country Hydro Tech Cyan Light Cutting and Polishing Pad - 4 inch

Now I need to figure out the steps
Remove the film protection
use foam gun with citrus wash to clean everything then I think i run water over the area I foamed, then wash with my mitt.

do this to entire car then switch foam gun to a pressure add on
start on rims with water pressure than use p21s gel let it sit for a bit while spraying wells. brush insides use small brusg for lugs then wash mitt clean use terminator for tar seal done.

then rewash whole car I believe this is where I can start clay bar.
then search for imperfections marring exc..

Use PC with 105 meg and pink cutting pad i believe on low speed then switch to 205 and Cyan Light Cutting and Polishing Pad to finish the polish. I dunno if I need to wash the car again or I can go straight to sealing the paint with diamond then let sure for 12 hour ish then I dont know if I need to rewash car before wax or if I can just wax need to read up more or if someone can answer.
Appreciate 0