Quote:
Originally Posted by BigRussia
You mean that JB4 power cable that goes into the green power connector with the orange cables yea? Should I just pull it from the green connector or the orange cable?
And I noticed my post was confusing but I can turn the limiter off and hit normal boost fine, my issue is just with the limiter not going above 4psi at any setting above 1k. Funny thing I'm running map 5 now, wonder if that could be a cause?
|
No. I mean disconnect the JB4 board completely. There is a black AMP connector that connects the wiring harness to the JB4. Disconnect that, and then follow the reset procedure I told you.
Or you can post your question here in the support section and you'll have ALOT more support since this is BMS's forum.
http://www.n54tech.com/forums/