Keep front camber bias on square setup?
I noticed that people run a at least .5 deg more of camber up front vs the rear on staggered wheel/tire combos.
I know the macpherson setup up front has very little if any dynamic camber, where the rear has quite a bit.
I am running a square WHEEL setup consisting of 18x9 et45 Front and Rear, however I am running 255's out back vs 245's up front.
Does anyone recommend I run square camber with this setup for street/track use? Also, I am running a 10mm spacer front vs a 5mm spacer rear. And lastly, my camber is maxed out with GC plates and coil overs at -2.3 deg.
Any ideas?
Last edited by Artsee; 05-07-2013 at 01:22 AM..
|