Quote:
Originally Posted by gnpower
+1. Structural integrity might be compromised, but if you were to place a CF insert like the GT-R, then the structural issues might resolved. Although, I don't believe engine bay heat would escape from that unless some engine bay modifications were done as well. You might be better off just using some CF wraps to accent the area.
|
Im not completely opening a slit. I will leave the horizontal pieces where I drew that black line. The side marker actually will cover that and it will look like a full slit exists. I think most of the strength though would be lost by removal at the top and bottom where the crease tapers. I dont plan on opening it up to a point like the vinyl inserts outline.