[cblounder]

I experienced a fault with my front brake wear sensor.

Yesterday, I experienced a service warning that I was
down to 0 miles and due for front brake service. Having
driven about 70 miles my service counter is now reading
nearly -400 miles.

After reading many post, I attempted to reset the service
indicator with no luck so I decided to inspect my sensor
and attempt to reconnect it as discussed by others.

I discovered that I have a broken wire but not sure were it
should connect to the back of the rotor. I have two sensors
in the drivers side front wheel well but the schematic only
show one sensor, which seem to be intact.

The car brakes fine and seem to have no other issues.

Please let me know what you all think.