Quote:
Originally Posted by Ian///M
I know it well
There are 4 plastic rivets (2 each side) which are a single use only. Just drill out the centre if each, then the OE diffuser can be pulled out starting one side to the other. The clips/tabs are quite secure though and it is a hard pop in/out.
Which one did you buy?
|
Just wanted to add some additional information to this thread.
The OEM diffuser is attached to the bumper via 4 plastic single-use pop rivets (6x21mm): Part # 51118222901
You can snip the tops off from above where the diffuser attaches to the bumper and then work the plastic rivet head free. As Ian///M pointed out the rest of the diffuser is attached via clips which are pretty snug.
To replace them with new blind rivets you'll need something like this tool:
http://www.harborfreight.com/hand-ri...ets-97757.html
(Apparently the heads on HF's standard rivet gun are too small to accommodate the plastic rivet pin on these pop rivets.)