Quote:
Originally Posted by fe1rx
That is a good find. Much cheaper than my convoluted experience!
|
Yes, but we have you to thank for that.
Also, did you see the toe arms we have made, as posted on a few boards (see https://www.e90post.com/forums/showthread.php?t=768710&page=2), with the following note:
Hey guys.
We have manufactured rear toe arms for the e82 and e9x non-M. The design principle is a curved arm, but with dimensions better suited to the non-M suspension.
These are made of billet 6061-T6 aluminum and have been precision CNC machined to accept either balljoints or bushings (which can be either stock bushings or much stiffer Group N bushings, or even some polyurethane bushings), or any combination of balljoints and bushings depending on individual preferences. They can be anodized in any colour. They can also be made either in the standard length (412 mm) or +3 mm for extra toe.
Because you can select balljoints or bushings, or any combination, you can tweak your effective spring rates in increments (measured in lb/in). So, for example, on effective spring rates:
- 2 balljoints: 0
- 1 balljoint and 1 regular bushing: 15
- 2 regular bushings: 30
- 1 balljoint and 1 Group N: 56
- 1 regular bushing and 1 Group N: 71
- 2 Group N: 112
Assuming the contribution of a full set of stock bushings is an equivalent of 109 lb/in, then that can be fully compensated with a set of MRP toe arms with 2 Group N bushings, and the other 4 arms can be only balljoints...
Just trying to gauge interest at this point so please reply if you might be interested in this product...