Quote:
Originally Posted by thebigragu99
Actually your all wrong about the autoclear setting..when a real code comes up ,it will not clear immediately.if this happens you should turn off auto clear and check the codes right away..a real code won't autoclear!!
|
I think that is where YOU are mistaken. Every code is a real code regardless of what it is. A fault code will clear when autoclear is on. When my JB4 autoclear was on, it cleared everything. It doesn't selectively clear some codes and leave others. When I had AC on and then disabled the JB4 to check with the BT tool, there were no codes at all. Now that I have the V3 DPFIX and my AC is disabled I can read my codes after taking the JB4 back to MAP 0.
Better peace of mind for me, but to each his own....