View Single Post
      09-29-2010, 03:33 PM   #34
1SerieStud
Brigadier General
1SerieStud's Avatar
183
Rep
3,939
Posts

Drives: '11 VO 1M (498 of 740)
Join Date: Jul 2010
Location: Jacksonville, FL

iTrader: (11)

Quote:
Originally Posted by GatorVert View Post
I go 6 ft, 210 lbs. I slide like a third-grader in those seats.

Perhaps my 'wet park bench' analogy was improper...I'll admit.

It's more akin to sitting on a wooden church pew covered in bacon grease.

BTW, unless you have some sort of scientific seat measurometer, isn't it pretty much the whole point of asking questions on this board to get...a subjective answer?

Man I couldn't care less about your analogies/opinions since I get to experience the same seats first hand...and yes most forums are opinion based. I guess instead of addressing your opinion directly, I should have just stated my opinion about your opinion being misleading instead

Here's another opinion for you including some scientific concepts since you seem to be so fond of them: I think the reason you're sliding around so much could be a result of not enough force pegging you to the seat due to a weaker engine. So in my opinion, I think you should have purchased a 135 instead, in order to amplify the Newtonian law of "for every action there is an equal and opposite reaction" which would equate to you against the seat as well as the seat against you
Appreciate 0