Quote:
Originally Posted by wuNasty
Harold can you explain what might need to be done to part 13 to get this to fit?
|
Two ways:
#1 remove(carefully cut around the base of it, a 1 minute job at the most) the two rubber moisture/dust sleeves so you can actually feed the firewall portion of the brace through the closing panel, then you can re-install the sleeve to still retain most of the moisture/dust barrier capabilities.
#2 buy a new closing panel with snap on sleeves as you see it in the illustration - #23 and #24. OEM ones are fused to the closing panel thus the need to cut them off.