so i have a question for you fine folks, today i installed my berk midpipe, and was working on my VRSF FMIC, when i ran into some issues..
i used a dremmel to cut out a good deal of plastic from the inside of the front bumper, but am still having issues with the hoses connecting to the intercooler..
i litterally have had screw drivers on these things trying to pry them in, but am not having any luck..
here are some photos of what i am working with, perhaps you guys could see something that i am not understanding, or missing?
Drivers side, will not go any further in
passenger side, as far as it goes
how its sitting, feels like its a little bit low?