**UPDATE**
Here is a few pictures from the installation on Mdawood's VO 1M.
Here you will see some comparison shots from a coupe different angles:
HERE IS A VERY IMPORTANT PICTURE FOR INSTALLATION
I highlighted the piece, in red, that needs to be pried out of the way for installation. Again, you do NOT need to cut or remove this piece. . .but if you want more airflow, I believe this piece can be removed without cutting, as it
appears like it is bolted in. This customer did not want it removed, so we left it in place.
Forge intercooler being installed, again please make sure you use good grease on the OEM rubber seals that will slide into the Forge intercooler, I suggest white lithium grease, used liberally.
Fits well for being a good deal bigger than stock, and not needing any trimming of any sort.
And a couple finished pictures, you can not tell anything's been done. You can also see the shroud that can be removed flanking the new intercooler. If it were my personal car, I would remove it.
Hope this helps some of you DIYers out there!
Let us know how it turns out!