|
Cleaned up my notes on coding the tire diameter correction for smaller 18" setup. I can confirm that running "execute job" with empty FSW_PSW.MAN will reset to stock.
After coding a few different times, I did the following sequence to try different settings:
1. Make sure time is set (it will be ---- after coding KOMBI)
2. Turn off ignition, remove key
3. Open door, Close door
4. Insert key, push start w/o clutch
5. Make sure OBD-USB is connected, COM9
6. Set FSW_PSW.MAN file to settings I wanted
7. Execute Job
Last edited by PRTSB1M; 10-11-2022 at 07:07 PM..
|