Quote:
Originally Posted by Donkeyshins
Here's what it looks like post-bending / post-install (I didn't bother painting it, because none of it is visible):
If I were to do it over again, I might try and get a flat / pre-bent bracket from Rennline and do the bends / painting myself since the bends aren't perfect and there was definitely some deformation from having to hammer some bits flat.
(come to think of it, I might just reach out to them and see if they'd be willing to sell me one) |
Did you try heating and bending in a vise or just hammered at it? Doesn't look too bad. Going to pull the trigger on it anyway. Thanks for being the guinea pig!