Major kudos to kfiducia! Thank you for the DIY... I am a newbie with this fuse/v1 install. I'm picking my V1 tomorrow after deciding that over a Solo S2 cordless.
Anyways went to Autozone today and picked up the following and I have some questions:
First this is what the Add-a-circuit looks like from autozone:
Second, do I just install one 20 amp to the Add-a-circuit? As seen below:
OR do I add two 10 amps to the Add-a-circuit? as seen below:
Quote:
Originally Posted by gan08
Finally got it! Thanks to Kfiducia's detailed instruction and everyone's help.
Got my mini "Add-a-Circuit" from autozone.
End up cutting the blue tip connector from the end of "Add-a-Circuit" then put on a female slide disconnect terminal then connect to V1's direct wire device.
|
Finally, gan08, did you end up using one of these:
22-18 disconnect female? as seen below:
OR did you end up using 16-14 disconnect female? as seen below:
Thank you for the response in advance!