Quote:
Originally Posted by int2str
I just did this last night. No real advice other than "pull". I did it with a short extension, a good "E" type bit (don't use a normal socket, use a "E" torx bit). I did it with a normal ratchet handle and a good amount of elbow grease. Wasn't too hard to break loose to be honest.
Don't forget to install the new bolt that comes with the kit - I missed it....
Untrue and un-helpful.
|
A M3 tower bar / strut brace will not fit a 135, you will need to mod the centre mount as the angle is not correct.
You need to make sure that you purchase the modded centre mount when you buy your kit.