Bumping this up to say thanks and pay it forward with a couple tips now that I did this install.
First, here is the link to the pick set I bought at Home Depot for less than $5, actually found it by accident while I was shopping for a set of Torx drivers.
http://www.homedepot.com/p/Husky-Pre...004H/204314893
(The 45 degree pick came in handy for picking tiny rocks out of my radiator and mending bent fins while I had the grills out, because I'm OCD like that
)
Lastly, regarding the rubber weather strip that goes along the top; you actually don't have to remove it completely. You only need to lift off the two ends that go over the headlights, you can leave the middle section on the bumper trim. This is handy since you wont have to worry about lining it up perfectly again when placing it back on the bumper trim if you removed it completely.
Hope this helps