Quote:
Originally Posted by JimD
In case I haven't made it clear already, I think it is worth the one time effort to put metal, hard rubber, or wood blocks into the plastic lifting pockets. I carry some in the shallow side of the tray under the trunk floor. The cost is low regardless of how you do it and I don't see another good alternative unless you want to spend $100 for 4 of the cast aluminum pieces. They seem like the best option but I didn't want to spend $100 on them. They would also be harder to carry in the car.
|
Ah F it I'll just go to home depot with the measurements and pick up some wood. It'll give me an excuse to start looking at wood for a new table anyways.
Do you know the dimensions of your inserts? If not its time to bust out the tape measure.