Quote:
Originally Posted by Die ///M Rakete
I remember reading a thread that explained how anything past 10mm would negatively affect the suspension geometry by adding negative scrub radius.
I ran 10mm all around and found it perfect.
|
i ended up ordering a 12mm and a 10mm set. i am thinking ill just run the 10mm in the front. i dont have too much issue with the rear.
Quote:
Originally Posted by 1&done
I have 10mm in the front and 5 in the rear. 10mm in the rear just looked to weird to me...plus I think it would rub as my M is on low in the back (O R&Ts.)
|
this sounds like a perfect setup. although i think what makes the most sense is buying lighter wheels with the appropriate spacing. just need to save up $$$$
Quote:
Originally Posted by Snertz
Not sure, usually the spacer sets come with longer bolts. Alternatively you can just got with a stud kit, which is the preferred route.
|
thought about that however i hate that you have to replace them from time to time. they are considered a consumable. basically dealing with high heat and stress overtime makes them weaker.