Quote:
Originally Posted by reisf
I asked another forum member who completed the same project. Naturally this is not the OEM way to do it, however no matter how far i searched (approx 1 month) i couldn't find the correct wiring diagram.
Pin 1 & 2 in the 4 pin connector, inside the MOST bus connector need to be bridged only.
BTW the remote turn on signal is sent over the MOST fibre optic bus, not pins 10&20 - you can use these or the larger 2 pins for power supply.
|
Yes, hard to know and I didn't find info about these before your post.
I thought it was using additional Mic for DIRAC and/or adaptive speed Volume.
Thanks about remote on signal info, didn't know the MOST way.
I 'm near to complete with wiring the on this Amp and coding, Will report my results (waiting for the power plug with the 2 pins to do all that).