|
I have the same problem as described above in the posts: when passenger window closes, it bounces back about 3-4 inches open.
After reading posts, I deduct window is somewhat loose from its "base" inside door. This is the reason window does not goes down fully inside door when fully opened and hence it will not get to reach it's fully up position when fully raised. The computer rather senses that some object is obstructing its travel, so then it bounces back open.
Don't know if new motor provides new harness for holding window tight. Setting aagain limits will only temporarily fix the problem until window continues to get loose and problem reappears again.
There was a post above that recommended fully opening window and pushing down on the glass so it gets fully inside door and in original limits. This sounds logic. Unfortunately in my case, when fully opened, I could not get window move down even a millimeter.
|