[Drawn05]

No problem

1. FRM is Fuss raum modul or foot well module - it controls all the lights and is located in the drivers footwell.

2. You can use NCS expert to alter the coding in the FRM to not check the status of the bulb, which will stop the errors. I have not done this myself and it does not seem easy as there are heaps of possible lines of coding to change for it to work.

3. From memory, it just locks those errors and they cannot be cleared - even if you put the bulbs back it will give an error - only a new FRM will fix this.

4. I installed factory xenons i.e. Headlamps, wiring harness, FRM3 and coded it.

I got most of my info from ********* dot com, but there is good info on e90post under DIYs and coding.

Take 2: b m w c o d i n g . c o m