Quote:
Originally Posted by BrokenVert
Quote:
Originally Posted by romak47
Not sure if u can tell from my picks but the lip is actually hollow in the middle. The top and bottom halves are all carbon. One long ass sheet top and one long ass sheet on bottom basically. The surface area seems pretty big and complicated.
|
Its not one sheet wrapped onto itself with a space inbetween? Thats not difficult to mould.
|
Your complaining about the cost based on size/carbon used for the rear diffuser compared to the front lip.
I was actually comparing my 3ddesign diffuser next the lip and the lip is considerably more carbon fiber because of the fact the scorpions lip is made of fiber top and bottom and longer than the diffuser.