Quote:
Originally Posted by paintpro21
In my first post I mentioned that they will be 18-19~lbs. and that they accept bmw oem roundel click in center caps, part #36 13 1 095 361.
The rear is not aggressive at it has the most conservative offset for the 1 series to date. the front is at an offset/size being run by other people already. IF we get enough people together I could tweak the offset to 40mm, but it would be a total waste of production to have a 2mm different wheel produced, since et38 works on every single other car out there.
We are producing these in 18x10" et25 and 18x9.5" et35. I'd go with the 18x10's if you can fit 18x9.5" et25, or the 9.5's could be run with a spacers. They'll have an aggressive concave face to them. and not the CSL style that is flat near the outer edge and then concave at the hub, but aggressive flat spokes angled inward
E46/E36 caliper fitment NOT 1 SERIES FITMENT shown below
|
Damn it, not going to work for me!
I am getting a front only widebody kit, so I still need the rear from the 1 series GB. But I need fronts to match! I don't want to use spacers as my car is a race/track car. Possible to custom make 18x9.5 et 25 for the front?