Another Breyton GTS-R setup
Wheels: Breyton GTS-R
Front: 18x 8.5 +48
Spacer: 5 MM
Rear: 18x 8.5 +48
Spacer: none
Tires:
Front Goodyear F1 Asymmetric 245/35/18
Rear Goodyear F1 Asymmetric 245/35/18
Suspension/Fender Mods/Camber:
Stock
Notes:
No rubbing so far although am guessing under full compression (turn) up front I might get some rub on outer fender. I have camber plates I plan to install just to be safe (and dial in better steering - negative camber) but may not be needed pending tire choice. Note: 5 MM spacer just barely allows tire to clear strut but should be sufficient while allowing least chance of rub on outer front fender. Ton's of room in rear. In fact I may add a 5 or 10 MM spacer to rears to match flush look of fronts. Square setup will allow me to rotate wheels.
__________________
DD & Track Car: 2011 E90 M3 w/Ohlin R&T's, Vorshlag camber plates, Hotchkis swaybars and other mods.
(2008 135i modded - SOLD, 2006 E90 330xi - SOLD, 1995 M3 track car - SOLD)
Last edited by TMc135; 04-19-2009 at 10:28 PM..
|