Quote:
Originally Posted by bradford
The problem with the OEM calipers is that the throat is too narrow. You simply can't get a rotor with sufficient thermal mass in there. The Stoptechs would be too thick. I don't have the exact specs on the OEM throat width but it is very visible looking at the OEM rotor. It's a decent diameter at 13.3" but it's skinny as hell. Looks like a record - makes the Stoptech one look like a manhole cover.
If you want to stick with the OEM setup (I sure didn't want to drop the 3 Gs on Stoptechs, but I'm a very aggressive track driver) your best bet is good fluid, Ti plates, try to stuff a duct in there (not really an option for me on a daily driven car that needs to be able to parallel park and still fit 245mm R-comps up front), and remove the OEM dust shields (or trim them and fashion a flange to use with the ducts to deliver air to the center of the rotor)
|
Assume you have stoptechs up front and oem rear?
Can you elaborate on shield mods without using air pipe? Remove completely or just lower half?
Iv'e seen a 300zx with air guides/funnels mounted to control arms. Anybody try this?