Wheels: Enkei NT-03
Front: 18x 8.5 +38
Spacer: 5mm
Rear: 18x 9.5 +58 (Hub centric to BMW but with a 5x120.65 bolt pattern from a Corvette)
Spacer: none
Tires:
Front Toyo R1R 255/35/18
Rear Toyo R1R 265/35/18
Suspension/Fender Mods/Camber:
KW Variant 3 Coilovers w/ HP Autowerks Springs, Vorshlag Camber plates @ max neg camber.
Front fenders rolled slightly.
Rear fenders rolled with a proper tool as of 03/09. (No more baseball bat!)
Approx 2" strip of the liner has been cut out in the rear.
Notes:
Rear is VERY LOW. No rubbing on the race track or during regular street driving. I was able to get it to mouse squeak of a rub once while going down a very steep driveway but otherwise I would call this a "no rub" setup!
And the disclaimer: Use the rear wheels at your OWN RISK! I have talked to several wheel manufacturers and the bolt pattern size difference is small enough that no machining is needed, but it IS NOT A BMW 5x120! Make sure the wheels balanced properly and you are using STEEL lug nuts or lug bolts with the proper torque. I use 90ft/lbs in the rear and 85ft/lbs in the front.