GIAC 1M Flash - Stock, 91 octane and 100 octane flash with dyno plots!

[HP Autowerks]

Originally Posted by hybris4u

Interesting! My Swedish 1M instruction book recommend 98 euro octane but also say it can be driven on 95 euro octane. So the recommendation is 93 US or 98 euro octane over here. Do you have the same recommendation for your US specced 1M? Just curious.

GIAC has flashes for 91 and 93 octane fuel, as well as 100 race fuel.

[E30 Racer]

Originally Posted by HP Autowerks

GIAC Stage 2, and Stage 2 Race Fuel maps are ready to flash as well!

Does the GIAC code disable the check engine light from a non-cat downpipe install?

[HP Autowerks]

Originally Posted by E30 Racer

Does the GIAC code disable the check engine light from a non-cat downpipe install?

It can be done on a special request and with a written letter that the vehicle is for off highway use only.

[E30 Racer]

Originally Posted by HP Autowerks

It can be done on a special request and with a written letter that the vehicle is for off highway use only.

Good to know. Thanks for the reply!

[Em/1]

Originally Posted by RPM90

Just checked one of my local fuel stations, and they have a PON 110 rated gasoline. Race gas basically.
It sells for about $6.40 per gallon. Not bad if you've got software for it, considering 93 is going for about $4.20 in my area.

Am also in Chicago--where did you find that stuff?

[Mahlzeit]

Originally Posted by HP Autowerks

You have the option to purchase additional maps, including the stock map. Along with the handheld switcher, you can switch maps before taking the vehicle into your local dealer.

Hold on, I have to buy my stock map back from GIAC?

[HP Autowerks]

Originally Posted by Mahlzeit

Hold on, I have to buy my stock map back from GIAC?

No, not to flash it back to stock. However, if you want stage 1 or stage 2 with race fuel and stock mapping switching, you must purchase the switcher along with programs you would like to have.

[Mahlzeit]

Ok, makes sense. Thx

[E30 Racer]

How much is the flash switcher above and beyond a tune?

[HP Autowerks]

Originally Posted by E30 Racer

How much is the flash switcher above and beyond a tune?

$150 for the handheld switcher.

And for those looking for Dynojet numbers...

[ozinaldo]

Originally Posted by HP Autowerks

GIAC Stage 2, and Stage 2 Race Fuel maps are ready to flash as well!

Harold,

I checked the GIAC USA web site but couldn't see any info. regarding this Stage 2. Is there any dyno chart available or some specific data which shows us what it brings in addition to Stage 1, which is well documented here.

Also pre-requisits are the same as Stage 1, dps maybe?

EDIT: Nevermind, I think I got it (the chart) from other threads. Still, I appreciate if you could post anything specific or new you may have on Stage 2 to avoid misunderstanding. It's been some time since someone reported on GIAC tune.

[Derek8819]

GIAC has one of the worst websites I've been on in awhile.

[ozinaldo]

Originally Posted by Derek8819

GIAC has one of the worst websites I've been on in awhile.

That's so true, Thomas was very helpful in Forums though, but don't even know what GIAC would do to promote their products without HP Autowerks.

[HP Autowerks]

Originally Posted by ozinaldo

Harold,

I checked the GIAC USA web site but couldn't see any info. regarding this Stage 2. Is there any dyno chart available or some specific data which shows us what it brings in addition to Stage 1, which is well documented here.

Also pre-requisits are the same as Stage 1, dps maybe?

EDIT: Nevermind, I think I got it (the chart) from other threads. Still, I appreciate if you could post anything specific or new you may have on Stage 2 to avoid misunderstanding. It's been some time since someone reported on GIAC tune.

This may be the same graph you saw on the other tread started by GIAC.

For Stage 2 you will need FMIC, intake and a cat back exhaust. Catless DP would be a nice addition, but not necessary.

There is also an latest update for Stage 2 with even more power, but I don't have the specifics or dyno chart. I should be getting this very new file soon for my personal 1M.

Originally Posted by Derek8819

GIAC has one of the worst websites I've been on in awhile.

You should make GIAC aware of this. Better from a customer than from a dealer. They will be more likely to listen.

[ozinaldo]

Originally Posted by HP Autowerks

This may be the same graph you saw on the other tread started by GIAC.

For Stage 2 you will need FMIC, intake and a cat back exhaust. Catless DP would be a nice addition, but not necessary.

There is also an latest update for Stage 2 with even more power, but I don't have the specifics or dyno chart. I should be getting this very new file soon for my personal 1M.

Thanks Harold for the clarification. Please post about the new file too when you have it in your 1M.

[Splinterz88]

Any updates regarding the revised GIAC Stage 2 Files? Thanks