BMW 1 Series Coupe Forum / 1 Series Convertible Forum (1M / tii / 135i / 128i / Coupe / Cabrio / Hatchback) (BMW E82 E88 128i 130i 135i)
 





 

Post Reply
 
Thread Tools Search this Thread
      11-09-2012, 04:05 PM   #1
Alcor
Private
 
Drives: 135i 2013 DCT
Join Date: Nov 2012
Location: Argentina

Posts: 50
iTrader: (0)

wich is the best panel air filter for n54 engine

http://www.bavarianx.com/aFe_Drop_in...w.30-10156.htm

http://www.bavarianx.com/Macht_Schne...ms.fil.n54.htm

http://kmsmotorsport.com/filters/pro...0-5-sided.html

http://www.burgertuning.com/bms_dropin.html

http://www.amazon.com/33-2367-High-P.../dp/B000V5WF6G


wich filter increase more the horse power ?
Alcor is offline  
0
Reply With Quote
      11-09-2012, 04:18 PM   #2
mlhj83
Scythe-Meister
 
mlhj83's Avatar
 
Drives: '11 E92 M3 DCT ZCP
Join Date: Aug 2011
Location: London

Posts: 1,029
iTrader: (0)

I wrote the following in a separate thread not too long ago:

As a rule of thumb, no air intake can give that much improvement if any. There is nothing wrong with the OEM intake. I wouldn't even change the oem filter. Credible studies have shown that most aftermarket filters don't filter particles as well as oem filters, which is not to say aftermarket filters are inferior in quality, but rather it's part of their design to have less filtration for increased air flow. High flow air filters are fine for racing applications, given that they are being run on a relatively clean environment of a race track and that the engine is either rebuilt or only meant to last for a few races. I honestly see no benefit in fitting aftermarket filters unless you are after aural aesthetics only. In fact, it would be more beneficial to change your oem air filter at half the normal BMW interval, compared to someone having an after market filter which they eventually neglect to clean on a regular basis.

Also, a lot of aftermarket intakes leave their filtration element exposed in the engine bay, which will cause the engine to suffer from heat soak if you are not travelling fast enough to supply sufficient cool air.

Hope this helps.
mlhj83 is offline   United Kingdom
0
Reply With Quote
      11-09-2012, 04:21 PM   #3
Dackelone
Moderator
 
Dackelone's Avatar
 
Drives: 135i Silber mit/Rot 6MT N54
Join Date: Feb 2010
Location: Bayern, Germany

Posts: 16,133
iTrader: (1)

Quote:
Originally Posted by mlhj83 View Post
I wrote the following in a separate thread not too long ago:

As a rule of thumb, no air intake can give that much improvement if any. There is nothing wrong with the OEM intake. I wouldn't even change the oem filter. Credible studies have shown that most aftermarket filters don't filter particles as well as oem filters, which is not to say aftermarket filters are inferior in quality, but rather it's part of their design to have less filtration for increased air flow. High flow air filters are fine for racing applications, given that they are being run on a relatively clean environment of a race track and that the engine is either rebuilt or only meant to last for a few races. I honestly see no benefit in fitting aftermarket filters unless you are after aural aesthetics only. In fact, it would be more beneficial to change your oem air filter at half the normal BMW interval, compared to someone having an after market filter which they eventually neglect to clean on a regular basis.

Also, a lot of aftermarket intakes leave their filtration element exposed in the engine bay, which will cause the engine to suffer from heat soak if you are not travelling fast enough to supply sufficient cool air.

Hope this helps.

+1. I am sticking to the BMW OE filter.

When I checked my air filter last year I was surprised by how many small rocks and sand were up inside the airbox. Just image if one were using a porous oiled air filter! Nein Danke.

I would just make sure your filter is clean and clear of debris.
Dackelone is offline   Germany
0
Reply With Quote
      11-09-2012, 04:22 PM   #4
Ian///M
Major General
 
Ian///M's Avatar
 
Drives: 1M
Join Date: Mar 2011
Location: AU

Posts: 6,243
iTrader: (0)

Drop in filters are a waste of money. Will give a small increase in induction noise, but worse filtration than OEM. Zero performance gain!

DCI's will give more HP at the top end revs, but I don't drive at 6k rpm, so again a waste.

Filtration vs small performance gain, I recommend filtration.
__________________
BMW 1M VO - Cobb + PTF e-Tune, Akrapovic wireless, MadDad mids, ETS 5" FMIC, ER CP, TurboSmart PB DV's, SSK, CDV, OCC, AWRON Gauge, Hankook RS-3's, Vorshlag Camber plates
Ian///M is offline   No_Country
0
Reply With Quote
      11-09-2012, 04:48 PM   #5
mlhj83
Scythe-Meister
 
mlhj83's Avatar
 
Drives: '11 E92 M3 DCT ZCP
Join Date: Aug 2011
Location: London

Posts: 1,029
iTrader: (0)

Especially with the air quality in the urban areas of Argentina, I would also vote for filtration over minimal gains.
mlhj83 is offline   United Kingdom
0
Reply With Quote
      11-09-2012, 06:35 PM   #6
Artemis
Brigadier General
 
Artemis's Avatar
 
Drives: 1M (VO)
Join Date: Jun 2011
Location: Belgium

Posts: 3,234
iTrader: (0)

See also the following threads:
http://www.1addicts.com/forums/showthread.php?t=688599 ("Air filters / induction kits")
http://www.1addicts.com/forums/showthread.php?t=605885 ("Experiences with the K&N filter for the 1M ?")
__________________
“For ’tis the mind that makes the body rich” (W. Shakespeare, The Taming of the Shrew, Act 4, Scene 3)
Artemis is offline   Belgium
0
Reply With Quote
      11-09-2012, 07:00 PM   #7
ozinaldo
Brigadier General
 
ozinaldo's Avatar
 
Drives: 1M
Join Date: Jan 2011
Location: Chile, Santiago

Posts: 3,045
iTrader: (0)

I bought a afe pro dry s drop in filter, did not arrive yet, I will try it for a short period of time before making a decision and let you know what I think like if there is anything recommendable. I doubt it myself before even doing that though
__________________
"The mark of a great car is one whose overall competence exceeds what you should expect from its individual components and the 1M does just that", Chris Harris.
BMW 1M-SOLD-: TECH: Evolve Race+N55mids, Evolve IC, Michelin PSS, ER cp, aFe filter, CDVx, Vorshlag camber plates, BMS OCC EXTERIOR: trunk spoiler, blacklines, black grills, IND goodies INTERIOR: Alcantara steering wheel, steel pedals, custom mats, MPower e-brake.
ozinaldo is offline   Chile
0
Reply With Quote
Post Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 01:13 AM.




1addicts
Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST