BMW 1 Series Coupe Forum / 1 Series Convertible Forum (1M / tii / 135i / 128i / Coupe / Cabrio / Hatchback) (BMW E82 E88 128i 130i 135i)
 





 

Post Reply
 
Thread Tools Search this Thread
      02-09-2013, 11:12 PM   #1
Hops128i
Lieutenant
 
Drives: 2010 128i, manual, sport pkg
Join Date: Aug 2010
Location: Silver Spring, Maryland

Posts: 441
iTrader: (0)

HDPE inspection, brakes

I want to do a HDPE but want to make sure my car will pass the tech inspection. In particular i'm concerned about the brake pads. Two clubs that I might do a HDPE with state the following about the pads:

"Brake pads/ shoes Good, with at least of pad material
visible? (Not just OK)"
or
"Brake pads — at least 1⁄2 original thickness remaining"

Now, i measured what i think to be the pad thickness to be 9mm, am i measuring it right? And does anyone know that the original thickness was for a 128i? I've searched everywhere and can't find this information!

Name:  BrakePadWear.JPG
Views: 312
Size:  170.9 KB

Last edited by Hops128i; 02-09-2013 at 11:32 PM. Reason: grammar
Hops128i is offline  
0
Reply With Quote
      02-10-2013, 05:53 AM   #2
Dackelone
Moderator
 
Dackelone's Avatar
 
Drives: 135i Silber mit/Rot 6MT N54
Join Date: Feb 2010
Location: Bayern, Germany

Posts: 16,382
iTrader: (1)

9mm of pad material is fine. You were not including the metal backing plate right? Minimum pad material is 3mm. I think new they are around 12mm's.

For the brake rotors - the minimum thickness is stamped on the rotor's edge. It should be something like 25.5 mm. IF you rotors are less than the stamped min thickness replace them. IF they are thicker (new is around 27mm) than you are ok. These specs are just for theory. You have to rotate the brake rotor and look for the min thickness stamping.

Also... if the edge of the brake rotor has a "lip" more than 2mm's, you should probably replace the rotors too.

For a HPDE... you will want to have fresh brake fluid - changed and bled. Most organizers of HPDE will not let you run without fresh brake fluid signed off by a repair shop.

Good Luck and have fun at the track!
Dackel
Dackelone is offline   Germany
0
Reply With Quote
      02-10-2013, 06:12 AM   #3
GaryS
Colonel
 
Drives: 2009 135i 6MT
Join Date: Feb 2010
Location: Maryland

Posts: 2,089
iTrader: (0)

Garage List
2009 135i  [3.25]
That's plenty of pad for a 2 day event. The 3/4 pad requirement is SCCA. You won't really need that much, and they won't send you home because of it. If you have only 1/4 left, the track inspector might say you should keep on eye on it.

The 1/2 pad requirement sounds like BMWCCA. They're not as easy-going as SCCA, but I'm pretty sure you could do an SCCA event and still have enough pad left to pass BMW club inspection.
GaryS is offline  
0
Reply With Quote
      02-10-2013, 08:42 AM   #4
Hops128i
Lieutenant
 
Drives: 2010 128i, manual, sport pkg
Join Date: Aug 2010
Location: Silver Spring, Maryland

Posts: 441
iTrader: (0)

thanks for the replies! I guess I haven't gone though much pad even though I have 35k miles on the car, but the indicator inside the car keeps saying I have 15k left for the last 25k, (I drive like 95% highway miles)
__________________
2010 128i manual, sport package, performance exhaust, Vorshlag camber plates, 245/45/17 ZII square on et 40 with rolled rear fenders.
Hops128i is offline  
0
Reply With Quote
      02-10-2013, 09:11 AM   #5
b1aze
Just one more taste...
 
Drives: 2010 135i
Join Date: Aug 2012
Location: Shirley, MA

Posts: 1,419
iTrader: (14)

Quote:
Originally Posted by Hops128i View Post
thanks for the replies! I guess I haven't gone though much pad even though I have 35k miles on the car, but the indicator inside the car keeps saying I have 15k left for the last 25k, (I drive like 95% highway miles)
Im in the same boat on my 135i. I wanted to get the pads changed from the dealer on their suggested service inverval, but they wouldnt because there was still like 9mm of pad left at the 30k mile check. I also drive 90% highway over 90miles a day. I hope AutoX this season will help!!
b1aze is offline   United_States
0
Reply With Quote
      03-01-2013, 02:11 AM   #6
HP Autosport
Lieutenant General
 
Drives: F80 M3
Join Date: Mar 2007
Location: Santa Barbara, Brembo, GIAC, Koni, Ohlins, Performance Friction, Quaife, Stoptech, Vorshlag

Posts: 11,261
iTrader: (29)

That is plenty for an average track, but a good weekend at Laguna Seca will sure go through OE pads!
HP Autosport is offline   United_States
0
Reply With Quote
Post Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 09:55 PM.




1addicts
Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST