03-11-2021, 04:44 PM | #1 |
Private
34
Rep 51
Posts |
Akrapovic Axleback for 1M
As it says in the title, looking for just the Akrapovic axleback for 1M. Based in Southern California but open to shipping too. Thanks. |
07-16-2021, 09:09 PM | #2 |
MSgt (ret)
568
Rep 2,116
Posts
Drives: VO 1M #739/740
Join Date: May 2010
Location: Where the car was born
|
I have one I took off my 1m but no longer have fob/switch to change exhaust from inside cab…. I just wired it open… shipping from Alabama?
__________________
|
Appreciate
0
|
07-18-2021, 09:13 PM | #3 |
Lieutenant
314
Rep 444
Posts |
If you get the wiring diagram for 135i, you can wire it to open the same as on that car (uses same solenoid) and will also open when you press M button (opens based on vanos position). This is way down my todo list, but will eventually write it up.
|
07-21-2021, 12:24 AM | #4 |
Private
6
Rep 99
Posts |
|
Appreciate
0
|
07-22-2021, 10:40 PM | #5 |
MSgt (ret)
568
Rep 2,116
Posts
Drives: VO 1M #739/740
Join Date: May 2010
Location: Where the car was born
|
Esker, thx, but let's see if OP is interested as this is their thread… I'll ping you when/if they decline
__________________
Last edited by Rikx1M; 07-22-2021 at 10:59 PM.. |
Appreciate
0
|
07-22-2021, 10:40 PM | #6 |
Private
34
Rep 51
Posts |
|
Appreciate
0
|
07-22-2021, 10:44 PM | #7 | |
MSgt (ret)
568
Rep 2,116
Posts
Drives: VO 1M #739/740
Join Date: May 2010
Location: Where the car was born
|
Quote:
__________________
|
|
Appreciate
1
Cogitoergosum34.00 |
07-22-2021, 10:57 PM | #8 |
MSgt (ret)
568
Rep 2,116
Posts
Drives: VO 1M #739/740
Join Date: May 2010
Location: Where the car was born
|
See attached photo for complete kit. Overall in great condition, the CF tips need reconditioning but everything else is clean and straight.
__________________
|
Appreciate
0
|
02-03-2022, 06:58 PM | #11 | |
Boost
1355
Rep 3,697
Posts
Drives: 135i M-Sport
Join Date: Feb 2014
Location: Valley of Silicon, CA - United States
|
Quote:
__________________
F80 M3 TrackBoi, Z4MC GarageBoi, 1M Clone StreetBoi
|
|
Appreciate
0
|
10-14-2022, 07:54 PM | #12 |
Lieutenant
314
Rep 444
Posts |
I haven't tried this yet, but looks like you might just need to tap power from somewhere (OE is fuse F17, which could be tapped at fuel leak module) and run the ground signal from pin 5 on one of the DME plugs. I'm also fairly certain that the vacuum source is the capped off tee fitting between pump and brake booster
Last edited by PRTSB1M; 10-14-2022 at 08:06 PM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|